Designed for use in air brake systems or cab controls
Machined from CA260, CA345 or CA377 brass
Cut tubing squarely- maximum of 15° angle allowable.
Check that port or mating part is clean and free of debris.
Insert tubing into fittings until it bottoms on seat.
Tighten nut with wrench until one thread remains visible on the fittings body; (this will allow for a number of remakes) or, the nut should be screwed down finger tight, then wrench-tightened according to the tube size used.
WARNING: This product contains lead, a chemical known to the State of California to cause cancer and birth defects or other reproductive harm.
Meets D.O.T FMVSS 571.106 and SAE J246
Utilize ribbed sleeve for compression and positive grip